This disk contains Windows 95 and 98 printer drivers
for the STAR Special Products SP298, SCP700,
DP8340, SP200, SP300, TSP200, TSP200J, TSP300, TSP400 
and TSP552 series.

**************
HINTS and TIPS
**************

The TSP412/442 must be switched to Line Mode.(FOR WINDOWS OR DOS)

The TSP4xx driver supports Data Pool Mode.

TSP400 barcode printing. The barcode is not
printed, when the barcode length exceeds the
maximum page width or when unprintable
characters are included.

TSP400 and Star Customer Display SCD-400 or
SP300 and Star Customer Display SCD-400
When you select the driver TSP4xx + SCD-400
or SP3xx + SCD-400, it is possible to print
on the display. You must select the font
'Display upper line' or 'Display lower line'
in the font selection box of your
application.

The SP212/216 with parallel Interface must be
switched to EC character set.

DIP switch 7:	ON
DIP switch 8:	OFF

The unprintable margins are 0.5 cm on both
sides.


The DP8340 with parallel Interface must be
switched to IBM character set#2

DIP switch 1:	ON
DIP switch 2:	OFF

The unprintable margins are 1.4 cm on both
sides.

On the SP2x6 and the DP8340 series, when you 
select the italic font. The printer prints red
color instead of italic.

Three different kind of papers are available
--------------------------------------------
Receipt:	Paper length changes according to the print data
Ticket:		Paper length stays fixed as it is set up in the
		page setting dialog box.
Label:		Only available on TSP412/442. This is for label
		printing. 
		IMPORTANT !!! You must set the Memory Switch for
		'Start Position Detect' to on 

Printer names
-------------
DP8340FC:	DP8340, parallel interface, roll paper
DP8340FD:	DP8340, serial interface, roll paper
DP8340SC:	DP8340, parallel interface, sprocket paper
DP8340SD:	DP8340, serial interface, sprocket paper

SP2x2:		SP200, serial or parallel interface, single color
SP2x6:		SP200, serial or parallel interface, black & red

SP312:		SP300, without cutter
SP342:		SP300, with cutter

TSP212:		TSP200, without cutter
TSP242:		TSP200, with cutter

TSP212J:	TSP200J, without cutter   (SN 9300 and 9301)
TSP242J:	TSP200J, with cutter with (SN 9300 and 9301)

TSP552:		TSP552, with cutter

TSP312:		TSP300, without cutter, using roll paper
TSP312 BM:		TSP300, without cutter, for label printing
			set start position detect to ON
TSP342:		TSP300, with cutter, using roll paper
TSP342 BM:		TSP300, with cutter, for label printing
			set start position detect to ON

TSP412:		TSP400, without cutter, using roll paper
TSP442:		TSP400, with cutter, using roll paper



You must set up the PAGE in whatever program you are using, 
if not all you will get is line feeds.
Make the margins as close to zero as possible and set the page width
to the size of the paper. 
Also in the printer driver, set the unprintable areas all to zero. 
This is for any Windows program.
DOS programs will not be able to use the Windows driver and
you will have to set up everything in that program.

If you still have problems call Tech Support at 800-782-7636.
